Sample jobs
- Sample project
A rumble on every spin
- Reported
- A six-year-old washing machine had started to roar on the spin and leave rust marks on the floor behind it.
- Found
- With the back panel off, rust ran down from the drum seal across the motor: water had been getting past the seal into the rear bearing.
- Done
- Bearings and seal replaced on a longer second visit, the motor cleaned and tested, and a full wash run on the highest spin.
Two visitsWashing machines
- Sample project
Fan oven stone cold
- Reported
- The light and the fan came on, but a built-in single oven would not heat on any fan setting.
- Found
- The ring element behind the fan cover had an open circuit. The top and bottom elements and the thermostat tested fine.
- Done
- A matching fan element fitted from the van, then a heat test to 200°C with a thermometer on the middle shelf.
One visitElectric ovens and hobs
- Sample project
Washes well, dries nothing
- Reported
- A washer-dryer washed normally but left every drying load warm and damp after two hours.
- Found
- Fluff had packed the condenser duct and the drying heater’s thermal cut-out had tripped and failed.
- Done
- Condenser duct cleared, a new cut-out fitted and a mixed load dried while the engineer checked the air temperature.
One visitWashing machines
Sample projects for a fictional business. The photographs are illustrative stock and do not show these jobs.
Get a quote
Got a fault like one of these?
Four short steps: the appliance, where and when suits you, how to reply, then a check. One way to reach you is enough.
Thanks, your request is ready.
Mendlow will reply within one working day to offer a day for the visit.
Nothing is booked until you have agreed a day with us.
Demo website: your request was not sent. Nothing was sent and nothing was stored.
Start another request